Calibration / Certification / Repair / Site Surveys

Calibration

We have an extensive range of calibration equipment including Primary Reference Deadweight Testers, Druck Electronic Testers, Master Test Gauges and other calibrated equipment. All testing is done in a controlled dedicated calibration room.

We offer one of the quickest testing and calibration turn round times for new gauges or customer supplied gauges. In some instances, depending on workload this can be same day. If turn round time is critical please contact us in advance to check.

Each gauge certified will physically be tested and issued with a unique serial number (unless gauge already has a serial number) and be permanently identified by normally engraving the back of the case or sometimes printing on the dial. A sealed Tested & Calibrated label is put on the gauge showing serial number, date certified and re-calibration due date (normally 12 months unless requested otherwise). A vinyl cap is fitted to protect the connection thread and prevent any test fluid leakage from contaminating packaging. Please be aware – many companies do not actually test the gauge when a standard test certificate is requested but rely on original manufacturing checks – this is not a true test certificate.

All our test equipment is annually sent to independent certification facilities (many companies test in-house against their own equipment). All certificates are traceable to National and International Standards or UKAS traceable is available in-house at extra cost. For full UKAS certification please phone for price.

 

Certification Charges

Pressure

1 Traceable to National & International Standards
2 Only available with Point To Point Calibration Certificate

The above charges are for testing and certification only. Any re-calibration or repair costs will be advised before proceeding. For most standard gauges it is usually more economical to buy a new instrument than to repair. In many cases worn parts may not be available from the original manufacturer and the instrument will not be repairable.

To see a sample of a Standard Test Certificate and Point to Point Calibration Certificate click on relevant link below.

Standard Test Certificate (Sample as a PDF document)

Point to Point Calibration Certificate (Sample as a PDF document)

 

Temperature

We can offer temperature testing and certification between –50°C and +600°C. Temperature testing is a far longer process than pressure. This is due to the time taken to generate temperatures and for the equipment to cool down to measure falling temperature points on the scale. Please allow approximately seven working days.

Please note all prices are ex vat.

Electrical & Mechanical

Please contact us for quotation.

Repair

For most standard gauges it is usually more economical to buy a new instrument than to repair. In many cases worn parts may not be available from the original manufacturer and the instrument will not be repairable.

Site Surveys

If required, an experienced instrumentation engineer can visit your site/sites with regard to any specific instrumentation problems or for a general instrumentation suitability survey.

Please contact us for charges or quotation.

 

Cewal UK Ltd
Unit 4CWoodhall Business ParkSudburySuffolkCO10 1WH
Tel: +44 (0) 1787 882038Fax: +44 (0) 1787 882039
Email: info@cewal.co.ukWebsite: www.cewal.co.uk